UniBridge Electronic Truck Scales come in a wide choice of sizes from 10′ to 195′ in both 9″ and 15″ models.

All commercial UniBridge truck scales fully comply with the rules and regulation of Handbook 44 and with current National Type Evaluation Program testing procedures & guidelines.

Truck scales capacities are from 30 tons to 150 tons with heavier capacity and extra wide models available on request.

The electronic truck scales are ideal for use under silos, next to buildings, or scale pits.

Standard Features
9″ – 12″ Profile Ideal where height or access pose any type of installation problem. Available in steel or concrete deck. Single module length up to 30′
15″ Profile Our standard Low Profile ia available in steel or concrete deck, with single module lengths up to 35′
Surface Mounted No pit required, only 9″ to 15″ high
UniBridge Parallel Link Suspension Standard on all models; this system permits simple service of load cells
UniLatch A UniBridge Exclusive – Standard on all Low Profile truck scales. This system reduces installation time and allows bridges to automatically self align & center as they are placed together. Bolts are virtually eliminated from the weigh bridge.
DL 9000 Load Cells Come with intrinsic lightning and voltage surge protection
Bump Bolts Eliminates check rods, speeds installation, and permits easier scale adjustment.
J-Box Mounted in vertical position for easy access, reducing moisture-related problems (rated at NEMA IV)
Conduit System Designed to protect cable and speed up installation
Jacking Pad Factory installed for use with hydraulic jacks
Construction Heavy-duty WF beams braced and tied with extra-heavy steel safety deck
Examined and Approved Meets or exceeds all requirements set forth in Handbook 44
Fully Electronic No moving parts
Steel Deck A UniBridge Exclusive – Uses extra-heavy, high-strength safety plate on all bridge decks
Safety Side Rail A UniBridge Exclusive – Radius side rails eliminate tire damage and make for a safer operation
Summing Boards Individual adjustment pots for each position and section on all scales; gaseous diodes are on all boards for added lightning protection
UniModular Design Modules designed for future expansion
Surface Preparation All surfaces are thoroughly sandblasted prior to finishing
Standard Finish Catalyzed UniBridge Epoxy Blue or Epoxy Gray paint
Bolt Down All anchoring is done after installation permitting perfect placement of scale
Should you have any comments or questions, please use this online contact form. A scale specialist will get back with you as soon as possible.